Nissan 350Z Stage 2 on the dyno: 331 HP and 378 Nm
A Nissan 350Z with the naturally aspirated 3.5 V6 came to us for Stage 2. We first measured it on our dyno in Danilovgrad, then wrote and tested the map. In the end it made 331 HP and 378 Nm, 31 HP and 32 Nm more than before.
331 HPSTAGE 2
+31 HPMORE THAN BEFORE
378 NmTORQUE
Before and after
BEFORE
STAGE 2
DIFFERENCE
Power
300 HP
331 HP
+31 HP
Torque
346 Nm
378 Nm
+32 Nm
Both runs were made on the same dyno in our workshop in Danilovgrad. A naturally aspirated engine has no turbo to add boost to, so this is a solid gain: about 10% more power and 9% more torque.
What we did
Baseline measurement. The car was measured on the dyno first, so we know exactly where we start.
Stage 2 engine software optimisation. The map was written for this car, not a ready-made file. Ignition and fuelling were tuned together, with the parameters checked on every run.
Decat. Exhaust system without a catalytic converter, with the software adapted to it.
Pops & bangs. Crackles from the exhaust when you lift off the throttle.
⚠️ Decat and pops & bangs are intended for off-road and motorsport use only. Check the regulations in your country.
Why on the dyno
Every project is done individually, with parameters checked before and after. No guessing, only measurements.
On the dyno you see the whole power and torque curve, not just the peak number.
If something isn't right, you see it on the dyno, not on the road.
You get before and after measurements, so you know exactly what you got.
Want a result like this?
Send us your car and the stage you want, and we will tell you what is possible. Tuners can order files through our file service.
📍 ASF.Tuning / ASF Motorsport, Danilovgrad, Montenegro
Buying a used car?
Check the vehicle history before you buy
Leave no car unchecked.
A carVertical report by chassis number (VIN) shows the mileage history, reported damage and theft, and earlier listings with photos, as far as data exists for that vehicle.